2/20/2023 0 Comments Lord of the rings bow and arrowThese can easily be rejoined as they have lots of tiny, tiny barbs which allows the vanes to join each other. The feather vanes will easily split to allow the wire to be wound around the feather shaft. Then wrap the wire around the feather shafts leaving a 1cm gap each time. Keep winding it to form about a 1cm band until it reached the feathers. This is to hold it instead of using glue. To wind the gold wire, make a shallow hole with a pin and poked the wire in. I also stuck them on a bit far from the end, so I cut the end a bit shorter. Because i'm impatient, I used super glue to stick the feathers to the shaft. I trimmed them using hair dressing scissors because they seemed to be the only scissors I had that could cut the feather. Then cut the feather around the template using a craft knife. I cut the template from thick paper and placed that over the feather, positioning it so that I could cut all my arrow feathers from the one feather. I trimmed the shaft a bit because it was quite thick in some areas. Cut the feather in half by cutting down the centre of the shaft with a craft knife. This feather I had was 30cm long and nice and wide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |